Appliance Error Code Lookup

Compressor running extended durations without reaching target temperatures.

Condenser Fan Malfunction: The cooling fan near the compressor at the back of the fridge has failed; often due to dust or a bad motor.

Communication Error: The display panel and the main control board are not talking to each other.

Freezer Fan Failure: The fan circulating cold air in the freezer has stopped; usually due to heavy frost buildup or a dead motor.

Freezer Sensor Error: The thermistor in the freezer is sending incorrect (or no) temperature readings to the main control board.

Ice Maker Fan Error: The fan that blows freezing air specifically into the ice maker compartment is blocked by frost or broken.

Ice Maker Sensor Error: The temperature sensor inside the ice maker is malfunctioning; preventing it from producing ice.

Defrost Heater Problem: The system cannot melt frost off the evaporator coils; leading to ice buildup that blocks airflow.

Defrost heater failed to warm coils past safety threshold.

Flow Sensor Error: The fridge is detecting an issue with the water pressure going to the ice maker or dispenser.

Refrigerator Fan Error: The fan responsible for blowing cold air into the fresh food section has failed or is blocked by ice.

Refrigerator Sensor Error: Similar to the FS code; but the thermistor in the fresh food section has shorted out or failed.

General fault code; if a code beginning with F appears alternating between F# and E# the dryer control has detected a problem that requires service.

General fault code; other F and E combination errors.

Main electronic control board relay/communications failure.

Oven sensor loop thermal fault reading values incorrectly.

Exhaust thermistor circuit resistance is completely open/shorted.

Drain fault; pressure switch stuck on full after cycle.

Console-to-control communication interface failure.

Water fill supply error; no water detected entering machine.