Part Number 7116 — What Part Is This and How to Confirm & Replace It

Understanding the Problem

Brief explanation: "7116" by itself is ambiguous — many manufacturers and part catalogs use short numeric references or internal codes that look like this. To fix a problem you think is related to "7116," you must identify the appliance brand/model and the OEM full part number (often there's a prefix like WP-, 316-, 670-, etc.). Below are practical steps to identify the correct part and replace it safely. Step-by-step diagnostic and repair instructions: 1) Gather appliance identification: - Locate the appliance model and serial number (usually on a sticker inside the door, on the back, or on the frame). Write both down or take a clear photo. 2) Inspect the physical part: - Open the access panel (unplug first) and photograph the suspect component and surrounding area. - Look for any stamped or printed codes on the part — many parts carry a longer OEM number or a manufacturer logo. 3) Match the prefix and context: - If 7116 is a shortened code, the real part number may be WP7116, 7116A, 7116-xxx, or included in a longer number. The appliance model helps cross-reference. 4) Use official parts resources: - Enter your appliance model into the manufacturer’s parts lookup (e.g., Whirlpool, GE, Samsung parts sites) or a reputable parts reseller to find the parts diagram and exact number. - Compare your photos to the diagrams — identify name and function (thermostat, switch, sensor, motor, control board, etc.). 5) Diagnose by symptom and test the component: - Use a multimeter to check continuity, resistance, or voltage where applicable (e.g., thermostats should show continuity at room temp, ignition coils have specific resistances, switches open/close). - Look for visible damage: burn marks, melted plastic, broken connectors, corrosion. 6) Order the exact OEM or a high-quality aftermarket replacement: - Don’t rely on the short numeric code alone; confirm the full OEM part number and compatibility with your appliance model. 7) Replacement (general safe procedure for most small electrical/mechanical parts): - Unplug the appliance or shut off the circuit breaker. If gas appliance, turn off gas supply. - Remove outer panels or access panels per model instructions (keep screws organized). - Photograph wiring before disconnecting. Label wires or use masking tape and a marker so reconnection is exact. - Disconnect connectors and remove mounting screws holding the old part. Replace with the new part and reattach wires and screws. - Reassemble panels, restore power/gas, and test the appliance through at least one cycle. Safety note: Always disconnect power (and gas for gas appliances) before accessing internal components. If you are unsure about diagnosing live electrical circuits or working on gas systems, call a qualified technician.

Common Symptoms

Varies depending on which component '7116' refers to. Typical symptoms include the appliance not powering on, not heating, not turning, intermittent operation, error codes, or visible damage at the location of the part.

Common Causes

• The 7116 code is incomplete or shorthand — the full OEM part number or prefix is missing.
• Wear, electrical failure, or mechanical breakage of the actual component that '7116' represents.
• Incorrect replacement due to misidentification (ordering wrong part number or wrong revision).

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions