79094111405 — What Is This Part and How Do I Replace It?

Understanding the Problem

Brief explanation: The number 79094111405 appears to be an OEM-style part number but does not clearly match a single widely-documented consumer appliance part in common public databases. That means before replacing anything you should confirm the part’s identity against your appliance’s model number or the manufacturer. Diagnostic and repair steps (numbered): 1. Confirm source information - Locate the appliance model number and serial number (usually on an inside panel, door jamb, or back panel). The part number must be matched to the appliance model for a correct identification. - If 79094111405 came from a parts sticker on the appliance, take a photo of the sticker and where it was found. 2. Cross-check the part number - Check the appliance’s parts diagram (manufacturer’s website or service manual) by entering the appliance model number. Look for 79094111405 in the parts list. - Use reputable parts retailers (OEM parts sites, RepairClinic, PartSelect, AppliancePartsPros) to search the number. If the search returns no results, try search variants (remove leading zeros, add dashes, or search with only the first 6–8 digits). 3. Identify the part by appearance and location - Open the access panel (power off and unplug first) and compare the physical part you have (or the sticker photo) to images in the parts diagram. - Note whether it’s electrical (wiring harness, thermistor, control board), mechanical (belt, roller, drum), or a consumable (filter, gasket). 4. Diagnose the symptom tied to the part - Match the appliance symptom (no power, not heating, loud noise, water leak, error code) to the likely parts from the diagram. - Use a multimeter to test electrical parts (continuity, resistance) and visually inspect mechanical parts for wear, cracks, or burn marks. 5. Obtain the correct replacement - Once matched to your model, order the OEM part number listed by the manufacturer. If 79094111405 turns out to be a cross-reference, the parts site will show the correct OE number. 6. Replace the part (general practical steps) - Turn off power at the breaker and unplug the appliance. If it’s a gas appliance, shut off the gas supply and light pilot per manufacturer instructions. - Remove the appropriate access panel(s) and take photos of connections and screw locations before disassembly. - Remove mounting screws/clips and carefully detach electrical connectors (use gentle leverage; pull connectors by the plug body, not the wires). - Install the new part in the reverse order: connect wiring, secure fasteners, and reassemble panels. - Restore power and test the appliance through a full cycle relevant to the repaired component (e.g., run a wash cycle, start the dryer) and check for proper operation and absence of leaks or unusual sounds. Safety note: Always disconnect power (and gas if applicable) before opening or working on any appliance. If you’re unsure about identifying the part or performing electrical tests, contact a certified appliance technician or the manufacturer’s service line. Incorrect parts or improper installation can damage the appliance or create safety hazards.

Common Symptoms

Varies depending on the actual part: common signs include appliance not powering on, specific functions failing (no heat, no spin, error codes), loud or unusual noises, leaks, or visible damage at the part location.

Common Causes

• Normal wear and tear or mechanical fatigue
• Electrical failure (shorts, open circuits, burned connectors)
• Physical damage, clogging, or corrosion from use or environmental exposure

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions