Part 78464588 — How to Identify What This Part Is and How to Replace It

Understanding the Problem

Brief explanation: You provided the OEM number 78464588 but not the appliance brand or model. Many manufacturers reuse numeric sequences for different components, so the same number can appear on control boards, harnesses, modules, or even packaging. The most reliable way to proceed is to identify the part physically and confirm fitment for your specific appliance model before buying or replacing it. Step-by-step diagnostic and repair instructions: 1) Confirm the appliance make and model: Find the appliance's model and serial number plate (usually inside the door frame, on the back panel, or on the underside). Write down brand, model, and serial number. 2) Locate the part on your appliance: If you already have a part with 78464588 printed on it, take clear photos of the entire part, front and back, and any connectors, mounting tabs, and the surrounding assembly. Note any molded part description (e.g., "control board", "harness", "thermostat"). 3) Cross-reference: Use the appliance model + "78464588" in the manufacturer's parts lookup (Whirlpool/Maytag/Frigidaire/GE/etc.), or a reputable parts website. If the number returns multiple results, compare images and connector type to your part. 4) Identify common candidates: If the number corresponds to an electronic module, symptoms will be electrical (no power, no response, error codes). If it’s a harness or switch, symptoms may be intermittent operation or a specific function failing (door latch, dispenser, heater circuit). 5) Basic electrical checks (for electrical parts): With the appliance unplugged, visually inspect for burn marks, corrosion, or broken traces. Use a multimeter to check continuity across fuses, switches, and connector pins as shown in the part’s schematic or wiring diagram. If it’s a control board, inspect electrolytic capacitors and solder joints for damage. 6) Functional isolation: Remove the suspected part and, if possible, swap with a known good part (from a donor unit) or bypass safely according to manufacturer guidance to confirm the fault before purchasing a replacement. 7) Order the exact OEM replacement: Once you have brand+model confirmation and matched the images, order the part that exactly matches the OEM number and connectors. Avoid buying a part that only looks similar. 8) Replacement steps (general): a) Unplug the appliance and turn off water/gas if applicable. b) Remove any panels necessary to access the part. Keep screws and note locations. c) Photograph wiring and connectors before disconnecting so you can restore them correctly. d) Disconnect connectors and remove mounting fasteners. e) Install the new part, reconnect wiring, and reassemble panels. f) Restore power and run a test cycle to confirm the repair. Safety note: Always disconnect power before working on electrical appliances. If the part involves gas, high voltage, or sealed refrigerant systems, consider a certified technician. If you’re unsure what the number refers to, provide photos and the appliance model and I can identify the part for you.

Common Symptoms

Variable depending on the part: complete loss of function (appliance won’t turn on), specific feature failure (no heating, no water fill, door won’t latch), intermittent operation, or visible damage to wiring or connectors.

Common Causes

• Part-specific electrical failure (burned traces, bad components on control boards)
• Mechanical wear or broken mounting tabs/connectors
• Corrosion or water damage to connectors or wiring harness

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions