1108756 Q10 — What Is This Part and How Do I Replace It?

Understanding the Problem

Brief explanation: I can't definitively identify 1108756 Q10 without the appliance make and model or a photo, because part numbering conventions vary between manufacturers. Below are practical diagnostic steps to identify the part, what to check first, and general step-by-step replacement guidance you can follow once you've confirmed the exact part. Step-by-step identification and diagnostic steps: 1) Locate the appliance model tag: find the appliance’s model & serial number (usually on the door jamb, back, or inside a kick plate). Record those and the part number stamped on the component or packaging. 2) Photograph the part: take clear photos showing the whole part, connectors, labels, and the mounting location in the appliance. That helps suppliers match it. 3) Search OEM parts databases: enter the appliance model and 1108756 (or 1108756 Q10) on major parts sites (appliancepartspros, searspartsdirect, repairclinic, manufacturer site). If no exact match, search only 1108756 and compare images. 4) Compare to schematics: pull the parts diagram (exploded view) for your model and locate the part number to confirm function (motor, valve, thermostat, PCB, connector, etc.). 5) Interpret symptoms at the appliance: match what’s happening (no power, won’t heat, leaks, erratic behavior) to the part type you found in diagrams—this narrows whether 1108756 is likely the cause. 6) Confirm with vendor or manufacturer: send photos + model tag to parts supplier or manufacturer support to confirm compatibility. How to fix (general replacement steps once the part is confirmed): 1) Order the exact OEM or approved aftermarket replacement using the confirmed part number and your appliance model. 2) Cut power: unplug the appliance or switch off the dedicated breaker. For gas appliances, shut off gas supply and disconnect per manual. 3) Take safety photos: before removing anything, photograph wiring and mounting so you can reinstall exactly. 4) Access the component: remove panels/doors to reach the part. Keep screws and fasteners organized. 5) Disconnect connectors: gently unplug wiring harnesses and label them if needed. For push-fit hoses, clamp and remove carefully to avoid fluid spills. 6) Remove mounting hardware: unscrew or unclip the part and remove it. 7) Transfer any brackets/grommets: move rubber mounts or brackets from the old part to the new one if needed. 8) Install new part: mount it, secure fasteners to the same tightness, reconnect wiring/hoses matching your photos/labels. 9) Restore power and test: plug in or restore power, run a test cycle and observe operation. Check for leaks, unusual noises, or error codes. 10) Final check and reassemble: if tests pass, reassemble panels and confirm proper operation. Safety note: If the part involves high voltage (control boards, heating elements), gas, refrigerant, or sealed refrigeration systems, or if you are unsure about wiring or gas connections, stop and contact a licensed technician. Incorrect installation can cause fire, electric shock, gas leaks, or refrigerant release.

Common Symptoms

Because 1108756 Q10 isn't tied to a specific make/model here, symptoms vary depending on the actual component: common signs include no power, appliance won’t run, intermittent operation, no heat, leaks, unusual noises, or specific error codes related to the failed component.

Common Causes

• Normal wear or component failure over time (motors, thermostats, valves, boards)
• Corroded or loose electrical connections causing intermittent faults
• Physical damage, overheating, or water exposure causing failure

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions