11029522800 — Which Appliance Part Is This and How Do I Replace It?

Understanding the Problem

I can't reliably identify part number 11029522800 from the number alone without the appliance brand and model. Part numbers are often re-used or formatted differently across manufacturers, so the same numeric string can refer to different components. Follow these steps to identify the correct part, diagnose the appliance problem, and replace the component safely: 1) Confirm appliance brand and model - Locate the appliance model and serial number (usually on a tag inside the door frame, behind a kickplate, on the back, or inside the control panel). Record brand, model, and full serial number. 2) Cross-reference the part - Enter the brand + model + "11029522800" into the manufacturer's official parts lookup or a reputable parts site. If the part number appears, read its description and view any available diagrams. - If the number does not appear, take clear photos of the part and of the appliance area where it mounts and compare to exploded diagrams for your model. 3) Match symptoms to the likely component type - Electrical failure (no power, intermittent operation): suspect control boards, switches, wiring harness or fuses/thermostats. - Heating failure (no heat or weak heat): suspect heating element, igniter, thermostat/thermistor. - Mechanical failure (won’t spin, noisy, door won’t latch): suspect motor, belt, pulley, hinges, latch assembly. - Leaks: suspect door seal, inlet valve, hoses, tub or drain pump. 4) Test the suspect part - For electrical parts: disconnect power and test continuity/resistance with a multimeter per the OEM specs. - For mechanical parts: inspect for wear, broken mounts, or seized bearings. - For sensors: test resistance/continuity and compare to expected values in service manual or online tech sheets. 5) Order the correct replacement - Only order the part after confirming the OEM part number for your exact model. Using a part that physically fits but isn't specified for your model can cause further damage. 6) Basic replacement steps (generic safe procedure; adapt to the specific part once identified) - Tools: screwdriver set, nut drivers, multimeter, needle-nose pliers, work light, replacement part, gloves. - Safety: disconnect power at the breaker for electrical appliances; for gas appliances also shut off the gas supply and, if unsure, call a pro. - Remove access panels: open/control panel, back panel, or bottom kickplate to access the part. - Photograph wiring and connectors before disconnecting so you can reattach correctly. - Disconnect wiring harness and remove screws/mounting hardware holding the old part. - Install the new part: reconnect wires to the same terminals, secure mounting hardware, replace panels. - Restore power (and gas if applicable) and run a function test. Check for leaks, proper operation, and error codes. Safety note: always disconnect power (and shut off gas where applicable) before inspecting or replacing parts. If you’re not comfortable with electrical or gas work, hire a licensed technician.

Common Symptoms

Unable to identify part from number alone; symptoms vary depending on what the part actually is — common appliance symptoms include no power, no heat, error codes, unusual noises, leaks, or mechanical failures.

Common Causes

• Part number applies to different components across brands; lack of brand/model data prevents exact identification
• Component failure from wear, electrical short, or mechanical damage
• Incorrect part ordered or incompatible replacement installed

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions