Maytag Washer Lid Lock (LID LOK) Error — What Part Fixes This Problem?
Need the replacement part? Search your model number at for guaranteed fit and fast free shipping.
Understanding the Problem
Many modern Maytag washers use a lid lock (safety interlock) that prevents the machine from spinning or agitating while the lid is open. When the washer displays a "LID LOCK", "LID LOK", "LID" or a similar lid-related error, the washer may not start, may stop mid-cycle, or the lid may remain locked and not release. This can be caused by a faulty lock assembly, a bad lid switch, wiring problems, or an electronic control issue. Because the lid lock is a safety device, the machine’s control board will refuse to operate if it does not receive the correct signal that the lid is closed and locked. Diagnosis usually starts with confirming the lid lock actuator and switch are working, checking harness connections and continuity, and then verifying the control board is commanding and getting a response from the lock. Physical wear, moisture, and mechanical damage are common failure modes on units that frequently run high-speed cycles or use heavy loads.
Common Symptoms
Washer displays "LID LOCK" or "LID LOK" error; washer won't start, won't advance cycles, stops mid-cycle, or lid stays locked and won't open after cycle completes.
Common Causes
- Failed lid lock assembly (mechanical actuator or internal switch failure)
- Broken or shorted wiring/harness or corroded connector to the lid lock
- Control board or user interface failing to command or read the lock correctly
Popular Parts That Fix This Problem
These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at PartsDiscount.com — just search by your appliance model number for a guaranteed fit.
Helpful Repair Tip
Run the washer's diagnostic/service mode to command the lid lock and listen for a click; if you hear nothing, check for 120V (or model-appropriate voltage) at the lock harness when the board commands it and test the lock for continuity with a multimeter.
Frequently Asked Questions
Can I bypass the lid lock to get the washer running?
You should not bypass the lid lock for regular operation. The lid lock is a safety device designed to prevent the washer from spinning with the lid open. While technicians sometimes use a bypass temporarily for diagnostics, bypassing the safety interlock is dangerous and may void warranties or violate local safety rules. The correct fix is to repair or replace the faulty lock, wiring, or control board.
How much does it cost to replace a Maytag lid lock?
Replacement lid lock assemblies typically cost between $30 and $150 depending on OEM vs aftermarket and model. Labor (if you hire a technician) generally ranges $100–$250 depending on local rates and whether additional diagnosis or control board replacement is needed. Always verify the correct part for your exact model number before purchasing.
Real DIY Repair Stories
Be the first to share your repair story!
Share Your Repair Story
Your experience helps other homeowners fix their appliances. Tell us how it went!
Can't Fix It Yourself? Find a Local Technician
It's perfectly okay to call a professional. Some repairs require specialized tools, deep teardowns, or dealing with complex systems that are better left to the pros.
Find the Right Part for Your Appliance
Don't guess — search your exact appliance model number at PartsDiscount.com to find the correct OEM compatible replacement part. They offer fast free shipping, guaranteed fit, and thousands of parts in stock.
Your Free Parts Videos
Whether your dishwasher won't drain, your dryer stopped heating, or your fridge isn't cold, we've created simple repair guides for the most common appliance problems homeowners face. Each guide explains what's going wrong, the most likely causes, and which replacement parts fix the issue. When you're ready to order, we link directly to PartsDiscount.com where you can search by model number and get the right part shipped fast.