Maytag MVWB835DW0 Water Inlet Valve – What Part Fixes This Problem?
Need the replacement part? Search your model number at for guaranteed fit and fast free shipping.
Understanding the Problem
The water inlet valve controls water flow into your Maytag MVWB835DW0 during fill cycles. When one or both solenoids or the valve assembly fail, the washer can refuse to fill, fill slowly, continuously fill, only fill with one temperature (hot or cold), or leak at the rear of the machine. Mineral buildup, debris in the supply lines, or a burned solenoid are the most common failure modes. Replacing the inlet valve is a common and straightforward repair. Before replacing it, confirm the problem by checking the supply hoses and screens for blockages, verifying the household water and shutoff valves are fully open, and testing the valve electrically during a fill cycle. If the valve is leaking externally or the solenoids show no proper electrical response, the valve assembly should be replaced to restore normal fill operation and prevent water damage.
Common Symptoms
Washer won't fill or fills slowly, only fills with hot or cold, water continues to run after fill, visible leak at the back of the washer, or error codes related to fill/flood conditions.
Common Causes
- Failed solenoid(s) inside the inlet valve (electrical coil burnout)
- Mineral deposits or debris clogging or jamming the valve plunger
- Damaged valve body or failed internal seals causing external leaks
Popular Parts That Fix This Problem
These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.
Helpful Repair Tip
To confirm the inlet valve is bad: shut off water, remove the rear access panel, disconnect the electrical harness, and use a multimeter to check each solenoid for continuity. Also run a diagnostic or a fill cycle and measure whether 120V (or the machine's supply voltage) reaches the solenoid when it should be filling—no voltage or no continuity indicates a faulty valve or wiring issue.
Frequently Asked Questions
How much does it cost to replace the water inlet valve?
The replacement inlet valve part typically costs between $40 and $120 depending on OEM vs. aftermarket. If you hire a technician, expect total labor + parts to range roughly $120–$300 depending on local labor rates.
Can I replace the water inlet valve myself?
Yes, most DIYers can replace the valve. Basic steps: unplug the washer, shut off and disconnect water supply hoses, remove the rear or top panel for access, disconnect the electrical connectors and hoses from the valve, swap in the new valve (transfer any gaskets/screens if required), reconnect everything, and test. Take pictures during disassembly to help with reassembly and confirm model compatibility before purchasing the part.
Related How-To Videos
Real DIY Repair Stories
Be the first to share your repair story!
Share Your Repair Story
Your experience helps other homeowners fix their appliances. Tell us how it went!
Can't Fix It Yourself? Find a Local Technician
It's perfectly okay to call a professional. Some repairs require specialized tools, deep teardowns, or dealing with complex systems that are better left to the pros.
Find the Right Part for Your Appliance
Don't guess — search your exact appliance model number at ProsourceParts.com to find the correct OEM compatible replacement part. They offer fast free shipping, guaranteed fit, and thousands of parts in stock.
Your Free Parts Videos
Whether your dishwasher won't drain, your dryer stopped heating, or your fridge isn't cold, we've created simple repair guides for the most common appliance problems homeowners face. Each guide explains what's going wrong, the most likely causes, and which replacement parts fix the issue. When you're ready to order, we link directly to ProsourceParts.com where you can search by model number and get the right part shipped fast.