Kenmore 11062922100 Dryer Thermal Fuse – What Fixes No-Heat or Overheating?
Need the replacement part? Search your model number at for guaranteed fit and fast free shipping.
Understanding the Problem
The thermal fuse is a one-time safety device inside the dryer’s exhaust/vent path that cuts power to the heating circuit if the dryer overheats. When the thermal fuse opens, the dryer commonly tumbles but produces no heat. A blown thermal fuse is often the symptom, not the root cause — it’s triggered by excessive temperature from restricted airflow or a failed heating component. Replacing the Kenmore 11062922100 genuine OEM thermal fuse usually restores heat when the fuse is the only failed component. However, you should always troubleshoot the reason it blew: clogged lint filter or vent, a faulty heating element or thermostat, or a stuck blower. Replacing the fuse without fixing the underlying cause will likely cause the new fuse to blow again and can mask a more serious issue.
Common Symptoms
Dryer tumbles but produces no heat; dryer may shut off mid-cycle; dryer trips thermal protection repeatedly; sometimes dryer won't start if the fuse is wired in the control circuit.
Common Causes
- Clogged or restricted exhaust venting (most common) causing overheating
- Failed heating element or internal short that overheats the circuit
- Faulty thermostats, high-limit thermostat, or other temperature controls
Popular Parts That Fix This Problem
These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.
Helpful Repair Tip
Confirm the fuse is faulty by unplugging the dryer, removing the fuse, and checking continuity with a multimeter — a good fuse shows near-zero ohms, a blown fuse shows open circuit. Also inspect and clean the venting before installing the new fuse.
Frequently Asked Questions
How do I test the Kenmore 11062922100 thermal fuse?
Unplug the dryer and access the thermal fuse (usually located on the blower housing or exhaust duct). Remove the wires, take the fuse out, and use a multimeter set to continuity or ohms. A good fuse shows continuity (near 0 ohms). If the meter reads open/no continuity, the fuse is blown and must be replaced. Always verify the venting and heating element to find why it blew.
Can I replace the thermal fuse myself and what should I watch for?
Yes — replacing the fuse is a common DIY repair if you have basic tools. Unplug the dryer, remove the dryer back or lower front panel per your model's service instructions, disconnect the old fuse and clip in or solder the new one as required, then reassemble. Important: never bypass the thermal fuse (dangerous and can cause fire). After replacement, clean the lint filter and fully inspect/clean the exhaust vent to prevent recurrence.
Related How-To Videos
Real DIY Repair Stories
Be the first to share your repair story!
Share Your Repair Story
Your experience helps other homeowners fix their appliances. Tell us how it went!
Can't Fix It Yourself? Find a Local Technician
It's perfectly okay to call a professional. Some repairs require specialized tools, deep teardowns, or dealing with complex systems that are better left to the pros.
Find the Right Part for Your Appliance
Don't guess — search your exact appliance model number at ProsourceParts.com to find the correct OEM compatible replacement part. They offer fast free shipping, guaranteed fit, and thousands of parts in stock.
Your Free Parts Videos
Whether your dishwasher won't drain, your dryer stopped heating, or your fridge isn't cold, we've created simple repair guides for the most common appliance problems homeowners face. Each guide explains what's going wrong, the most likely causes, and which replacement parts fix the issue. When you're ready to order, we link directly to ProsourceParts.com where you can search by model number and get the right part shipped fast.