AFT-DC97-16350S — How to Identify What This Part Fixes and How to Replace It

Understanding the Problem

Brief explanation You provided the part number AFT-DC97-16350S but not the appliance model. That part number format is commonly seen on OEM service parts (often Samsung-branded) where the exact function depends on the appliance model (washer, dryer, refrigerator, range, etc.). The key first step is to identify which appliance and which component the number corresponds to using the appliance model and the manufacturer's parts diagram. Step-by-step diagnostic and replacement steps 1) Confirm appliance model and locate parts diagram - Find the appliance model number (usually on a sticker inside the door, on the cabinet frame, or on the back of the appliance). - Use that model number to look up the official parts diagram or service manual (manufacturer website, authorized parts dealer, or a parts diagram site). - Search the parts diagram for DC97-16350S or AFT-DC97-16350S to identify the component name, function, and orientation. 2) Match the physical part - Power off and unplug the appliance or turn off its breaker. - Access the area where the suspected part is located (consult service manual for panel removal instructions). - Compare the physical item to photos/diagrams for the part number. Confirm connectors, mounting points, and dimensions match. 3) Inspect for visible damage - Look for burned marks, cracked plastic, broken tabs, frayed wires, or oil/grease contamination. - If the component is electrical, inspect connector pins for corrosion or bent pins. 4) Test the part (if applicable) - For electrical parts: use a multimeter to check for continuity, resistance value per the service manual, or expected voltage while the appliance is powered and operating (only if you are trained and comfortable doing live tests). - For mechanical parts: check free movement, alignment, and whether springs or gears are intact. 5) Source the correct replacement - Order the exact OEM part using the appliance model + the part number from an authorized parts supplier. Avoid generic substitutes unless the compatibility is confirmed. 6) Replace the part - Safety first: unplug appliance or turn off breaker. - Remove access panels following the service manual. Keep screws and small parts organized. - Document or photograph connector pin locations before unplugging wiring harnesses. - Remove mounting screws/clips holding the old part and carefully extract it. - Install the new part in reverse order: secure mounting, reconnect wiring harnesses to the correct pins, reassemble panels. 7) Test appliance operation - Restore power and run a relevant cycle or operation to verify the repair. - Observe for correct function and listen for abnormal noises; re-check mounting and wiring if issues remain. Safety note Always disconnect power before opening the appliance. If live electrical testing is required, use appropriate PPE and only perform it if you are experienced. When in doubt, hire a qualified appliance technician.

Common Symptoms

Symptoms depend on the specific component identified by AFT-DC97-16350S but common signs of a failed part include the appliance not starting, intermittent operation, error codes, unusual noises, leaks, or a door/hinge/cover that won't latch properly.

Common Causes

• Component age and wear (mechanical parts wear out over time)
• Electrical failure from power surges, moisture, or short circuits
• Physical damage during use or service (broken tabs, connectors, or seals)
• Improper installation or mismatch of a non-compatible replacement part

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions