110.45862400 Front Seal – Washer Front Seal Leak and Replacement Guide
Need the replacement part? Search your model number at for guaranteed fit and fast free shipping.
Understanding the Problem
The front seal (OEM part 110.45862400) is the rubber gasket that seals the area where the tub meets the washer's front panel. When this seal cracks, tears, or becomes compressed, water can escape the tub during fill or agitation and collect under or in front of the machine. Leaks commonly develop from age, heat exposure, detergent build-up, or damage caused during maintenance or shipping. A failing front seal may also allow debris to bypass the tub barrier, leading to dirt buildup and faster wear. Replacing the front seal restores the watertight connection between the tub and cabinet; correct installation and cleaning of mating surfaces is essential to prevent repeat leaks. If left unaddressed, leaks can damage flooring and internal components such as the motor, wiring, or bearings.
Common Symptoms
Water pooling at the front or under the washer, damp or moldy odor near the door/front panel, visible cracks or deformation in the rubber seal, or water dripping only during fill and agitation cycles.
Common Causes
- Age-related rubber deterioration (cracks, hardening, compression set)
- Physical damage during maintenance, drum removal, or shipping
- Debris, detergent residue or mineral buildup preventing a tight seal
- Improper installation or missing/loose retaining clamps/springs
Popular Parts That Fix This Problem
These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.
Helpful Repair Tip
To confirm the front seal is the leak source, dry the washer, place dry paper towels under the front panel, run a short wash (cold fill + agitation), and watch where moisture appears — if it shows at the bottom front edge near the seam, the front seal is likely the culprit.
Frequently Asked Questions
How hard is it to replace the front seal?
Difficulty is moderate. You’ll typically need to disconnect power and water, remove the washer front panel (and possibly the door boot or trim), remove the old seal and any retaining spring, clean mating surfaces, then fit the new seal and secure it. Expect 45–120 minutes depending on model and experience. If the model has welded or hard-to-reach panels, consider a service manual or professional help.
Can I patch a leaking front seal instead of replacing it?
Temporary patches (sealants or tape) might slow a small leak but are not a reliable long-term fix because the rubber is usually compromised. Replacement with the correct OEM seal (110.45862400 for compatible models) is the proper repair to restore a watertight seal and prevent further damage.
Related How-To Videos
Real DIY Repair Stories
Be the first to share your repair story!
Share Your Repair Story
Your experience helps other homeowners fix their appliances. Tell us how it went!
Can't Fix It Yourself? Find a Local Technician
It's perfectly okay to call a professional. Some repairs require specialized tools, deep teardowns, or dealing with complex systems that are better left to the pros.
Find the Right Part for Your Appliance
Don't guess — search your exact appliance model number at ProsourceParts.com to find the correct OEM compatible replacement part. They offer fast free shipping, guaranteed fit, and thousands of parts in stock.
Your Free Parts Videos
Whether your dishwasher won't drain, your dryer stopped heating, or your fridge isn't cold, we've created simple repair guides for the most common appliance problems homeowners face. Each guide explains what's going wrong, the most likely causes, and which replacement parts fix the issue. When you're ready to order, we link directly to ProsourceParts.com where you can search by model number and get the right part shipped fast.