DC97-16350D — What This Samsung Part Is and How to Diagnose or Replace It

Understanding the Problem

Brief explanation: DC97-16350D is an OEM part number used by Samsung. The suffix (A, B, C, D) often indicates a revision. Without the appliance model it’s not possible to say with 100% certainty what the part does, but you can identify and replace it using the steps below. Follow these numbered diagnostics and repair steps to confirm the part's identity, test whether it’s faulty, and replace it safely. 1) Confirm the part identity - Locate your appliance model number (usually on a sticker inside the door opening, on the cabinet edge, or on the back). - Search the model number + "parts diagram" or "schematic" on the manufacturer site or reputable parts retailers (e.g., RepairClinic, PartSelect, SamsungParts). Look up DC97-16350D in the exploded parts diagram for that model — that will give the official part name (e.g., latch, harness, bracket, sensor). - If you have the physical part, compare photos: match mounting points, connector shape, number of wires/pins, and labels. 2) Visual inspection and basic checks - Power: Unplug the appliance or switch off the breaker. - Inspect the part for obvious damage: broken plastic, melted connectors, corrosion, burned components, or water damage. - Check connectors: ensure pins are straight and wires are solidly crimped. 3) Functional tests (generic, modify based on identified part) - Electrical parts: use a multimeter to check continuity/resistance per the service manual. For switches/locks, test continuity across actuated and non-actuated states. For solenoids or valves, check coil resistance against spec. - Sensors: check voltage reference and signal with the appliance powered and the component connected if it’s safe to do so. Refer to wiring diagram for expected values. - Mechanical parts: verify free movement, proper seating, and correct alignment. 4) Remove and replace (generic safe procedure) - Safety first: unplug appliance or shut off breaker and turn off water if applicable. - Access: open the panel necessary to reach the part (door trim, control console, rear panel). Keep screws organized and note their location. - Photograph wiring and connectors before disconnecting to ensure correct reassembly. - Disconnect connectors (use a small flat screwdriver to release locking tabs if needed) and remove mounting screws or clips. - Swap in the new DC97-16350D part (compare new vs old side-by-side to confirm match). Reconnect connectors and re-secure mounting screws. - Restore power and run a test cycle/operation to confirm the problem is resolved. 5) If problem persists - Re-check wiring harnesses and adjacent components. Some failures are symptoms caused by upstream electronics (control board, power supply) or by related mechanical parts. Safety note: Always disconnect power before working on electrical appliances. If you are not comfortable performing electrical tests or disassembly, hire a qualified technician. Use insulated tools and follow anti-static precautions when handling control boards.

Common Symptoms

Symptoms vary by the actual component that DC97-16350D represents, but typical signs include: appliance not starting or not responding to controls, a door or lid not latching correctly, leaks (if a water-related part), unusual noises, or error codes that point to the specific assembly.

Common Causes

• Wear and tear or broken mechanical parts (plastic latches, hinges, or brackets)
• Electrical failure (open coils, burned contacts, shorted sensors)
• Corrosion or physical damage from water, impact, or overheating

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions