DA31-00342A — What Part Is This and How Do I Fix Problems It Causes?

Understanding the Problem

You supplied the part number DA31-00342A but didn’t include the appliance brand or model. Many OEM part numbers are tied to a specific manufacturer and model year, so I can’t positively identify the component without that context. Follow these steps to confirm the correct part and then replace it safely: 1) Confirm appliance brand and model: find the appliance model and serial tag (usually on the refrigerator door jamb, behind a lower kickplate, inside the oven door frame, or on the washer/dryer tub). Write down brand, model number, and serial number. 2) Cross-check the part number: enter DA31-00342A plus the brand/model into the manufacturer parts lookup (manufacturer website, authorized parts dealer, or an online OEM parts diagram). Match the part image and mounting points to the part in your appliance. 3) Verify symptoms and part function: once identified, read the OEM description for the part (ice maker, water reservoir/tank, bracket, inlet fitting, etc.) and compare the failure symptoms you see (leak, no ice, no water, noise). If symptoms match the part’s function, proceed to replacement. 4) Order the correct part: ensure the part comes with any required gaskets, screws, or connectors. OEM parts are preferred for reliable fit and function. 5) Prepare tools and workspace: typical tools — Philips and flat screwdrivers, nut drivers (1/4"–5/16"), needle-nose pliers, towel/bin for water, bucket, flashlight, and optionally a multimeter if the part is electrical. 6) Safety first: unplug the appliance and shut off the water supply (for refrigerators/ice makers/washers). If the repair involves refrigerant lines, stop and call a licensed technician. 7) Remove access panels/shelves: open doors, remove food/water, take out shelves/drawers obstructing access. Keep small parts sorted. 8) Document connections: photograph wiring harnesses, hoses, and bracket orientation before removal so reassembly is exact. 9) Remove the old part: carefully disconnect electrical connectors (use a small screwdriver to release locking tabs), loosen clamps on hoses, and remove screws or clips. Retain fasteners unless the replacement includes them. 10) Install the replacement: mount the new part in the original orientation, connect hoses and wiring, tighten clamps to avoid leaks, and replace any gaskets or seals. 11) Reassemble and test: replace panels and shelves, restore power and water, and run functional tests (dispense water, make ice cycle, check for leaks, listen for abnormal noises). Monitor for 24–48 hours to ensure the repair holds. 12) If problems persist: check related components (valves, sensors, connectors, control board) and error codes; if refrigerant, sealed-system, or complex electrical issues appear, call a certified technician. Safety note: always disconnect power and water before repairs. If the part is part of the sealed refrigerant system or requires soldering/brazing or specialized tools, do not attempt — call a licensed appliance/refrigeration technician.

Common Symptoms

Symptoms depend on what DA31-00342A actually is: commonly reported issues for ambiguous refrigerator parts include water leaks, ice maker failures (no ice or slow ice), no water dispense, error codes, or unusual noises.

Common Causes

• Worn or cracked hoses / seals causing leaks
• Failed electrical connector, sensor, or motor (no operation)
• Physical damage, broken mounting clips, or corrosion

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions