110922756 — Identify Which Appliance Part This Is and How to Replace It

Understanding the Problem

You supplied part number 110922756 but not the appliance make/model; that number alone can refer to different components for different manufacturers. Below is a practical step-by-step process to identify what 110922756 is, confirm whether it’s the part you need, and how to replace it once identified. 1) Confirm the appliance make, model, and serial number - Look on the appliance for the data plate or sticker (commonly inside the door, on the rear panel, beneath the cooktop, or behind the toe-kick). Record make, full model number and serial. This is the single most important step. 2) Photograph the existing part and surrounding area - Take clear photos showing the part, its shape, mounting points, wire connectors, and where it sits relative to other components. Include any stamped numbers on the part itself. 3) Use authoritative parts lookups - Visit the appliance maker’s official parts website or an OEM parts diagram site (e.g., parts.whirlpool.com, searspartsdirect.com, appliancepartspros.com). Enter the appliance model — not just the part number — and check the exploded diagrams for a matching part number and name. 4) Cross-check the part number and description - Once you find 110922756 on a parts diagram, note the exact part name and verify the pictured shape, connectors and mounting match your photos. Check fit notes (left/right versions, color, harness included). 5) Order the correct replacement - Order OEM or exact-equivalent parts using the confirmed model + part number. Avoid guessing from a partial match. 6) Basic removal and replacement steps (generic; follow the manufacturer diagram once part is identified) - Safety: unplug the appliance or turn off breaker; turn off water supply for washers/dishwashers if applicable. - Prepare: move appliance away from wall, remove panels as directed by service manual to access the part. - Label & photograph wiring: take photos of all wire locations and connectors; use masking tape and a marker to label connectors if needed. - Remove fasteners: remove screws/clips holding the part, gently detach connectors and any hoses. Keep all hardware and note orientation. - Install new part: transfer gaskets or seals if required, mount the new part in the same orientation, tighten fasteners to firm (do not overtighten plastic threads), reconnect wiring/hose. - Reassemble and test: reattach panels, restore power and water, run a diagnostic or normal cycle to confirm the repair. 7) Troubleshoot if it still fails - If problem persists, test related components (fuses, thermostats, control boards, wiring harnesses). The parts diagram will show linked components that commonly fail together. Safety note: Always disconnect power before servicing. If you’re unsure about working with mains voltage, gas, or pressurized water connections, stop and contact a licensed technician. If you provide the appliance make and model (or a clear photo of the part in-place and the appliance data plate), I can identify 110922756 precisely and give exact replacement & wiring instructions.

Common Symptoms

Varies by part; common signs that a replacement is needed include: appliance won’t start, intermittent operation, loud or unusual noises, leaks, failure to heat, no spin/drain, door/latch faults, or visible damage to the component.

Common Causes

• Normal wear and mechanical fatigue (bearings, belts, latches)
• Electrical failure from voltage spikes, burned connectors, or shorted coils
• Physical damage, corrosion, or blockages causing secondary failures

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions