11068002011 — What This Part Is and How to Confirm or Replace It

Understanding the Problem

Brief explanation: I couldn't definitively match 11068002011 to a single OEM part without the appliance brand and model. Part numbers that long are commonly OEM numbers from major manufacturers (Whirlpool, Maytag, Frigidaire, GE, etc.) and can refer to electrical components, switches, brackets, or modules. Below are step-by-step diagnostics and repair instructions you can follow to identify the part and replace it. Step-by-step identification and diagnostic steps: 1) Confirm the part label and location: - Locate the part on the appliance and copy any other numbers or text from the label, molded date codes, and the connector shape. Note where it mounts (control panel, motor, burner, valve, etc.). 2) Get the appliance's model & serial number: - Find the appliance model/serial tag (usually inside the door frame, behind a kickplate, on the back, or inside the cabinet). Use that number when searching parts databases or calling support. 3) Search trusted parts sources: - Enter the appliance model + “11068002011” into manufacturer parts sites (WhirlpoolParts, SearsPartsDirect, PartSelect, RepairClinic). If no match, search just the appliance model to see exploded diagrams and cross-reference visual matches. 4) Compare visually and functionally: - Compare the unknown part’s shape, mounting holes, connector type, and wiring to exploded diagrams or photos. Identify whether it’s mechanical (bracket, pulley), electrical (switch, thermostat, harness), or electronic (control board, PCB). 5) Test the part if applicable: - For electrical parts: unplug appliance, remove part, check for continuity and proper resistances with a multimeter. For thermostats/thermistors, measure resistance and compare to spec. For switches, verify switching action and continuity when actuated. 6) Basic replacement steps (generic): - a) Safety first: unplug appliance and turn off water and gas (if applicable). - b) Take reference photos of wiring and the part’s orientation before removal. - c) Remove any access panels (typically screws or clips) to reach the part. - d) Disconnect electrical connectors (use a small flat tool if needed) and note harness positions. If screws/mounting tabs secure the part, remove them. - e) Install the replacement part in reverse: mount, reconnect wiring according to photos, replace panels. - f) Restore power/water/gas and run a test cycle to verify proper operation. 7) If you can’t identify the part or tests are inconclusive: - Take clear photos of the part (front, back, mounting points, connectors) and the appliance tag. Contact the appliance manufacturer’s parts department or post images to a reputable repair forum or parts supplier for identification. How to fix (practical actions): - Order the exact OEM replacement once you've confirmed brand and model and matched the part visually or by diagram. - If the part is electrical and fails continuity tests, replace it. If it’s mechanical (cracked, worn), replace it. - If the part is an electronic control or module and you’re unsure, consider ordering from a supplier with a good return policy and ensure compatibility. Safety note: Always disconnect power before touching internal components. For gas or water appliances, shut off supply lines and relieve pressure as needed. If you're not comfortable working with electricity, gas, or sealed systems, hire a qualified technician.

Common Symptoms

Symptoms depend on what the part is: appliance won't start, intermittent operation, error codes, heating failure, leaks, unusual noises, or visible damage at the part location.

Common Causes

• Normal wear and tear or mechanical breakage
• Electrical failure (open/shorted switch, burned connector, failed sensor)
• Incorrect part identification or failed/mismatched replacement

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions