11013212200 — What Part Is This and How Do I Replace It?

Understanding the Problem

Short explanation: I can't definitively identify 11013212200 without the appliance make and model. Many manufacturers reuse numeric sequences and the same number can refer to different parts on dishwashers, washers, dryers, ovens or refrigerators. Below are clear, practical steps to identify the part, diagnose it, and replace it once you have the correct replacement. Step‑by‑step identification and diagnostic steps: 1. Find the appliance model and serial number: locate the model/serial tag (usually on the door frame, inside the kick panel, behind a grille or on the appliance frame). Write those down — they allow a definitive parts lookup. 2. Look up the part using the manufacturer parts site or a reputable parts dealer (example: WhirlpoolParts, PartSelect, RepairClinic). Enter the exact model number and search for 11013212200. If the site returns a match, note the part name and view the diagrams. 3. Physically locate the part: open the access panel identified in the parts diagram and visually confirm the part number printed on the component or its packaging. Take a photo for reference. 4. Compare symptoms to the part function: once you know the part name (thermostat, valve, heating element, sensor, harness, etc.), match common failure symptoms to your appliance problem (no heat, no water, won't start, leaks, strange noises). 5. Electrical checks (if applicable): disconnect power, remove the component and test continuity with a multimeter. Record resistance and compare to expected values in the service manual or parts listing. 6. Functional checks (if applicable): for sensors and thermostats you can test with an ohmmeter; for motors check windings for continuity and bearings for free rotation; for valves check that they open/close electrically. 7. Order the correct replacement: order the exact part number returned for your appliance model. Avoid buying based only on 11013212200 if you did not confirm model compatibility. 8. Replacement steps (generic safe procedure — adapt to the specific part): a. Unplug the appliance or switch off the correct circuit breaker. For gas appliances also turn off gas supply. b. Turn off water supply if working on a valve or water component. c. Remove the access panel(s) required (use screwdriver/socket). Keep screws organized. d. Photograph wiring and take labels or color reference. Disconnect electrical connectors — pull on the connector body, not the wires. e. Remove mounting screws or clips holding the old part, then remove the old part. f. Transfer any mounting brackets, gaskets, or insulating pieces to the new part. g. Install the new part, reconnect wiring, secure mounting hardware. h. Reinstall access panels, restore power/water/gas and run a test cycle. 9. Verify repair: run the appliance through the function that was failing and confirm the symptom is fixed and no new leaks, noises, or errors appear. Safety note: Always disconnect power (and gas/water when relevant) before opening an appliance. If you are unsure about working on gas, mains wiring, or sealed refrigerant systems, call a qualified technician.

Common Symptoms

Because 11013212200 isn't uniquely identifiable here, symptoms vary by part: common signs include appliance not starting, no heat, no water, leaking, intermittent faults, or error codes; match the symptom to the exact part once identified.

Common Causes

• Part failure due to age, heat, corrosion or mechanical wear
• Electrical failure: open winding, burned connector, or intermittent contact
• Physical damage from impact, water intrusion, or improper installation

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions