Kenmore Part 106505099 Funnel – What This Part Does and How to Replace It

Understanding the Problem

What the part is: Part 106505099 is listed as a funnel used on some Kenmore appliances to direct liquid (water, detergent, or drainage) or ice/water flow within a subsystem (examples: washer fabric softener/dispenser funnel, refrigerator/ice maker funnel, or dishwasher drain funnel). Because manufacturers sometimes reuse small parts across models, the exact function depends on your appliance and model number. Below are diagnostic and replacement steps you can follow for any funnel-style part: 1) Confirm compatibility: locate your appliance model number (usually on a sticker inside the door, on the tub rim, or on the back). Use that model number to confirm the part 106505099 fits your exact model via the manufacturer parts diagram or a trusted parts supplier. 2) Inspect the funnel: remove the dispenser/cover or access panel to visually inspect the funnel for cracks, deformation, clogging, or disconnected hoses. Look for leaks, mineral buildup, or pieces missing. 3) Test the symptom: run a short cycle (or manually pour water/detergent) while watching the funnel area to confirm misdirection, overflow, clogging, or leakage. For ice maker/refrigerator funnels, check for ice jams or water bypass during a dispense. 4) Remove panels and disconnect power/water: before replacing, unplug the appliance and shut off the water supply if applicable. Remove any trim, dispenser housings, or access panels to reach the funnel. 5) Disconnect attachments: note how hoses, retaining clips, or screws attach the funnel. Photograph connections for reassembly. Remove hoses (have a towel ready), unclip fasteners, and remove the old funnel. 6) Clean surrounding area: clear mineral deposits, residue, or debris that could damage the new funnel or cause immediate failure. 7) Install new funnel (106505099): position the new funnel, reconnect hoses and clips in the original orientation, and secure any fasteners. Ensure seals or gaskets are seated correctly. 8) Reassemble and test: reattach panels, restore power and water, then run a cycle or test dispense to verify the leak/clog/misdirection has been corrected. 9) Final checks: monitor for a few cycles to confirm there are no intermittent leaks or fitment issues. Safety note: Always disconnect power before working inside an appliance and shut off water supply for any plumbing connections. If you cannot access the part without removing major components or if electrical/water plumbing is involved and you are not comfortable, consider calling a professional technician.

Common Symptoms

Leaks or drips around the dispenser/ice maker, detergent not being directed into the tub, overflow or poor dispensing, clogging, or visible crack or deformation in the funnel piece.

Common Causes

• Cracked or broken funnel housing from impact or age
• Mineral buildup or debris obstructing flow
• Loose or damaged hose/clips that connect to the funnel
• Incorrect or mismatched replacement part (fitment issue)

Popular Parts That Fix This Problem

These are the most common replacement parts that fix this problem. When you're ready to order, click below to find the right part at ProsourceParts.com — just search by your appliance model number for a guaranteed fit.

Frequently Asked Questions